ZD High Pressure Pump System
The Zide High Pressure Pump System consists of two major parts: the Controller and the Pump Unit. These two units connect to each other with signal and power lines. Controller systems are custom made for each Pump Unit, so it will not be suitable to connect this Controller to a different Pump unit.
Introduction and Specifications:
The Controller is designed to control the output pressure of the pump through a feedback loop from a pressure sensor and a built-in timer to control the On/Off time of the pump unit.
Please refer below to the electrical specifications and features of the Controller Unit:
- Input Voltage: AC 110V or 220V (manually select through internal switch)
- Input Frequency: 50 or 60 Hz
- Maximum Output Power: 200Watts
- Maximum Pressure Setting: 70 Kg/cm²
- Pressure Display Unit: Kg/cm², PSI (pound per square inch), BAR
- Setting Range: 10 seconds ~ 60 minutes
- Pressure Release Valve output: 0.1 Amp
- Water source control valve output: 0.1 Amp
- Flow rate options: 500 cc/min or 1.2 L/min @ 1000 PSI
Our Pump User Manual : ZD-100 Pump controller user manual-V4